Sale!

Generic HX711 Load Cell Weighing Sensor 24-bit A/D Conversion Module for Arduino

860.00 (as of February 20, 2018, 2:38 am) 189.00

The Load Cell Amplifier is a small breakout board for the HX711 IC that allows you to easily read load cells to measure weight.
By connecting the amplifier to your microcontroller you will be able to read the changes in the resistance of the load cell and with some calibration you’ll be able to get very accurate weight measurements.
This can be handy for creating your own industrial scale, process control, or simple presence detection.

Buy product

Category:

Description

Description:

The Load Cell Amplifier is a small breakout board for the HX711 IC that allows you to easily read load cells to measure weight.
By connecting the amplifier to your microcontroller you will be able to read the changes in the resistance of the load cell and with some calibration you’ll be able to get very accurate weight measurements.
This can be handy for creating your own industrial scale, process control, or simple presence detection.
The HX711 uses a two wire interface (Clock and Data) for communication.
Any microcontroller’s GPIO pins should work and numerous libraries have been written making it easy to read data from the HX711.

Specification:

Automatic power-on reset circuit
Simple digital control and serial communication: All are controlled by input pins, the chip registers without programming
Selectable output data rate of 10Hz or 80Hz
Simultaneous rejection of 50Hz and 60Hz power interference
Power consumption (including power supply circuit): Typical operating current: <1.7mA, shutdown current: <1μA
Operating voltage range: 2.6 ~ 5.5V
Operating temperature range: -20 ~ + 85 ℃

Package Includes:

1 x Load Cell Amplifier Breakout Board

The Load Cell Amplifier is a small breakout board for the HX711 IC that allows you to easily read load cells to measure weight.
By connecting the amplifier to your microcontroller you will be able to read the changes in the resistance of the load cell and with some calibration you’ll be able to get very accurate weight measurements.
This can be handy for creating your own industrial scale, process control, or simple presence detection.
The HX711 uses a two wire interface (Clock and Data) for communication.
Any microcontroller’s GPIO pins should work and numerous libraries have been written making it easy to read data from the HX711.

Additional information

Brand

Reviews

There are no reviews yet.

Be the first to review “Generic HX711 Load Cell Weighing Sensor 24-bit A/D Conversion Module for Arduino”

Your email address will not be published. Required fields are marked *